MPSTP2E 433Mhz rolling code radio transmitter.
Programming instructions:
1. Taking a PSL etched working remote, point at gates
2. Press both buttons at same time and red light goes on
3. Release and then press both buttons again until light flashes
4. Take new remote and press left hand button
5. Wait 5 to 10 seconds for the system to reset
5. The new remote will now be programmed
6. If using an older non-etched remote to programme new type, look for pinhole in back of working remote and insert pin/paperclip, when LED lights up remove pin/paperclip, take new remote and press the left hand button until the LED lights up
7. Wait 5 to 10 seconds for the system to reset.
7. The remote will now be programmed.
Programming without existing remote control
1. Locate receiver and open, press programming button inside and the LED lights up.
2. Press left hand button on new remote control and the LED on the remote will light up and the LED on the receiver will flash.
3. The LED on the receiver will go out after 5 to 10 seconds indicating the system has reset.
4. The remote will now be programmed.
Changing Batteries
1. Loosen screw at base of remote control and open
2. 2 x 3v Ithium (CR2025) batteries required
3. Fit new batteries taking care to align correctly and holding them on their outside edges
4. Replace and tighten screw
